Calcitrol™ Water Slide Calcium Remover
Calcitrol™ is a highly concentrated non-fuming low pH organic salt liquid which aids in the removal of calcium carbonate, calcium silicate and other hard to remove soluble salts that cling to the surfaces of water slides
and metal / fiberglass aquatic structures. Calcitrol™ is more effective, biodegradable, contains no VOC’s or phosphates and safer than other surface damaging etching acids such as hydrochloric and phosphoric acid.
Calcitrol™ is recommended to be used to remove the strongest hard water mineral residue, water line scum and calcium scale build-up on the interior surfaces of water slides. It is also used as a surface prep product prior to waxing or refinishing water slides and priming metal / fiberglass aquatic structures such as slide towers, stair treads and splashground spray features.
DIRECTIONS FOR USE
“THIS PRODUCT IS NOT A CLEANER OR DEGREASER”. For Calcitrol™ to be effective, the product must come in direct contact with the calcium scale build-up or hard water mineral residue. Any dirt, grease, body-grime, bird droppings, wax, sun tan lotion and other surface contaminants should be washed first with SlideRenu® SlideDetergent™ (Refer to Product Data Sheet for Application Instructions). After the surface is washed, it should be rinsed with potable quality water (hot recommended) through a pressure washer. To remove calcium carbonate, a white, crusty deposit one year old or less, dilute 1 part product with 1 part water in a plastic container. To remove calcium silicate, a white-grayish, hard to remove crusty deposit more than one year old, use full strength. “ALWAYS POUR CALCITROL™ INTO WATER AND TEST FIRST ON A SMALL AREA” before descaling the entire surface. Apply Calcitrol™ directly onto the substrate by using a synthetic bristle scrub brush, spray bottle, pump-up sprayer or plastic garden watering can with sprinkling head. Product should begin foaming as it reacts with the calcium scale residue. Light sand using 320 sand paper to remove heavy scale build-up. The product should remain on the surface for approximately 5-10 minutes and then thoroughly rinsed with plenty of clean potable water (hot recommended) through a pressure washer. Allowsurface to dry before polishing, waxing or top coating.
• APPEARANCE: Clear/Bland Liquid
• ODOR: Strong Acid Scent
• COVERAGE: 500 Sq. Ft. / Gallon of Mixed Solution (1 Part Calcitrol™ with 1 Parts Water) ALWAYS POUR Calcitrol™ INTO WATER.
• VOC’s: 52% by Weight
• PH: 1.0 –2.0
• SHELF LIFE: 24 Months. Keep From Freezing. Thaw Before Use.
• APPLICATION TEMPERATURE: 50F – 100F.
• FLAMMABLE: No
• BIODEGRADABLE: Yes
WARNING: Irritant. Harmful if swallowed.
PRECAUTION: Avoid contact with eyes. Do not take internally.
FIRST AID:In case of eye contact flush with water. If irritation persists see a physician. If swallowed do not induce vomiting, give patient large quantities of water, followed by 1 or 2 glasses of milk if available. Consult a physician immediately.
DO NOT MIX THIS PRODUCT WITH ANY OTHER CHEMICALS
KEEP OUT OF REACH OF CHILDREN
NOTICE: Manufacturer makes no warranty express or implied, nor accepts any responsibility for any direct or consequential damages beyond purchase price because manufacturer cannot control or effect use. Manufacturer will not be responsible for any injury, loss, or damage, if product is used in any manner not in compliance with label directions or if precautions are not observed. For chemical emergency, spill or accident,